MediaMatrix nTouch 180 Manuel télécharger pdf (Page 52)

Chapter 6 - Maintaining the nTouch 180 unit

48 Version 1.7.2.0 March 27, 2015

Viewing hardware status information

 Open the web interface, then navigate to the Hardware screen.

A table of information about the hardware is displayed.

The first time the page is displayed, a tilde (~) symbol is shown instead of the CPU Load

figure. You must refresh the page in order to see the calculated figure. Each time you

refresh the page, the CPU Load figure is recalculated, based on the time since the page was

last refreshed. The maximum time interval used for the calculation is 30 seconds.

Viewing firmware status information

 Open the web interface, then navigate to the Versions screen.

The screen shows the version of firmware loaded on the nTouch 180 unit.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58

Pas de commentaire

MediaMatrix nTouch 180 Manuel Page 52